diff --git a/printer_data/config/BTT/btt_eddy.cfg b/printer_data/config/UNUSED/btt_eddy.cfg
similarity index 100%
rename from printer_data/config/BTT/btt_eddy.cfg
rename to printer_data/config/UNUSED/btt_eddy.cfg
diff --git a/printer_data/config/btt_eddy.cfg b/printer_data/config/btt_eddy.cfg
new file mode 100644
index 0000000..707f39d
--- /dev/null
+++ b/printer_data/config/btt_eddy.cfg
@@ -0,0 +1,31 @@
+
+[mcu eddy]
+serial: /dev/serial/by-id/usb-Klipper_rp2040_504450612086291C-if00 # This is the serial address of your eddy probe. This can be found by using the terminal of your klipper instance (typically through SSH) and using the command ```ls /dev/serial/by-id``` 
+restart_method: command
+
+[probe_eddy_ng btt_eddy]
+sensor_type: btt_eddy
+i2c_mcu: eddy
+i2c_bus: i2c0f
+x_offset: 0 # INSERT VALUE FOR YOUR PROBE POSITION
+y_offset: 36 # INSERT VALUE FOR YOUR PROBE POSITION 
+reg_drive_current: 15
+tap_target_z: -0.6
+tap_start_z: 3
+tap_mode: butter
+tap_threshold: 135
+tap_samples: 5
+tap_max_samples: 10
+tap_samples_stddev: 0.025
+tap_speed: 2
+tap_adjust_z: -0.225
+
+[temperature_sensor btt_eddy_mcu]
+sensor_type: temperature_mcu
+sensor_mcu: eddy
+min_temp: 10
+max_temp: 100
+
+[temperature_sensor btt_eddy]
+sensor_type: Generic 3950
+sensor_pin: eddy:gpio26
\ No newline at end of file