From 7fa507cdbf049e483cf072575a02c4884ed8c3d9 Mon Sep 17 00:00:00 2001 From: pi Date: Thu, 17 Apr 2025 09:29:59 +0100 Subject: [PATCH] cartographer.cfg modified - 17/04/25 - 09:29:55 --- printer_data/config/TOOLHEAD/cartographer.cfg | 28 +++++++++++++++++++ 1 file changed, 28 insertions(+) diff --git a/printer_data/config/TOOLHEAD/cartographer.cfg b/printer_data/config/TOOLHEAD/cartographer.cfg index e69de29..850dbce 100644 --- a/printer_data/config/TOOLHEAD/cartographer.cfg +++ b/printer_data/config/TOOLHEAD/cartographer.cfg @@ -0,0 +1,28 @@ +[mcu scanner] +#canbus_uuid: 0ca8d67388c2 +serial: usb-Cartographer_614e_2B0021000F43304146393320-if00 +# adjust to suit your scanner, if using usb change to serial + +[scanner] +mcu: scanner +# Offsets are measured from the centre of your coil, to the tip of your nozzle +# on a level axis. It is vital that this is accurate. +x_offset: 0 +# adjust for your cartographers offset from nozzle to middle of coil +y_offset: 23 +# adjust for your cartographers offset from nozzle to middle of coil +backlash_comp: 0.5 +# Backlash compensation distance for removing Z backlash before measuring +# the sensor response. +sensor: cartographer +# this must be set as cartographer unless using IDM etc. +sensor_alt: carto +# alternate name to call commands. CARTO_TOUCH etc +mesh_runs: 2 +# Number of passes to make during mesh scan. + +[temperature_sensor Cartographer_MCU] +sensor_type: temperature_mcu +sensor_mcu: scanner +min_temp: 0 +max_temp: 105 \ No newline at end of file