diff --git a/printer_data/config/CUSTOM/set_material.cfg b/printer_data/config/CUSTOM/set_material.cfg
index e1e91dd..822119f 100644
--- a/printer_data/config/CUSTOM/set_material.cfg
+++ b/printer_data/config/CUSTOM/set_material.cfg
@@ -588,10 +588,8 @@ gcode:
             # Set bed heater to a high temp (120°C) to warm chamber indirectly
             SET_HEATER_TEMPERATURE HEATER={bed_heater} TARGET=120
 
-            #Call the non blockin temp loop
-            UPDATE_DELAYED_GCODE ID=check_bed_temp DURATION=1
-#            # Wait until bed reaches temperature
-#            TEMPERATURE_WAIT SENSOR="{bed_heater}" MINIMUM=120
+            # Wait until bed reaches temperature
+            TEMPERATURE_WAIT SENSOR="{bed_heater}" MINIMUM=120
 
         {% else %}
             # Chamber is already close enough to the desired temperature
@@ -606,36 +604,15 @@ gcode:
     # === FINAL BLOCKING WAIT ===
     {% set message = "[CHAMBER HEAT] Waiting for chamber to reach " ~ wait_temp|string ~ "°C..." %}
     RESPOND MSG="{message}"
-    # Call Delayed Gcode to monitor chamber temps.
-    UPDATE_DELAYED_GCODE ID=check_chamber_temp DURATION=2
-    
-#    # Block until the chamber temp sensor reads the required temp
-#    TEMPERATURE_WAIT SENSOR="{sensor}" MINIMUM={wait_temp}
-#
-#    # Confirm chamber is ready
-#    {% set message = "[CHAMBER HEAT] Chamber ready at " ~ printer[sensor].temperature|round(1)|string ~ "°C" %}
-#    RESPOND MSG="{message}"
 
-[delayed_gcode check_chamber_temp]
-gcode:
+    # Block until the chamber temp sensor reads the required temp
+    TEMPERATURE_WAIT SENSOR="{sensor}" MINIMUM={wait_temp}
+
     # Confirm chamber is ready
-    {% if printer[sensor].temperature >= wait_temp - 1 %}
-        {% set message = "[CHAMBER HEAT] Chamber ready at " ~ printer[sensor].temperature|round(1)|string ~ "°C" %}
-        RESPOND MSG="{message}"
-    # Call until the chamber temp sensor reads the required temp
-    {% else %}
-        UPDATE_DELAYED_GCODE ID=check_chamber_temp DURATION=2
-    {% endif %}
+    {% set message = "[CHAMBER HEAT] Chamber ready at " ~ printer[sensor].temperature|round(1)|string ~ "°C" %}
+    RESPOND MSG="{message}"
+
 
-[delayed_gcode check_bed_temp]
-gcode:
-    {% if printer[bed_heater].temperature >= 119 %}
-        {% set message = "[BED HEAT] Bed reached 120°C, continuing..." %}
-        RESPOND MSG="{message}"
-    {% else %}
-        # Reschedule delayed G-code until the temperature is met
-        UPDATE_DELAYED_GCODE ID=check_bed_temp DURATION=1
-    {% endif %}
     
 [gcode_macro M106]
 rename_existing: G106