[mcu scanner]
#canbus_uuid: 0ca8d67388c2 
serial: /dev/serial/by-id/usb-Cartographer_614e_2B0021000F43304146393320-if00
#    adjust to suit your scanner, if using usb change to serial

[scanner]
mcu: scanner            
#   Offsets are measured from the centre of your coil, to the tip of your nozzle 
#   on a level axis. It is vital that this is accurate. 
x_offset: 0                          
#    adjust for your cartographers offset from nozzle to middle of coil
y_offset: 23                         
#    adjust for your cartographers offset from nozzle to middle of coil
backlash_comp: 0.5
#   Backlash compensation distance for removing Z backlash before measuring
#   the sensor response.
sensor: cartographer
#    this must be set as cartographer unless using IDM etc.
sensor_alt: carto
#    alternate name to call commands. CARTO_TOUCH etc      
mesh_runs: 2
#    Number of passes to make during mesh scan.

[temperature_sensor Cartographer_MCU]
sensor_type: temperature_mcu
sensor_mcu: scanner
min_temp: 0
max_temp: 105

[gcode_macro PROBE_CALIBRATE]
gcode:
    CARTOGRAPHER_CALIBRATE