Add files via upload

Fiddling around with non blocking temp waits

printer_data/config/CUSTOM/set_material.cfg

@@ -588,8 +588,10 @@ gcode:
             # Set bed heater to a high temp (120°C) to warm chamber indirectly
             SET_HEATER_TEMPERATURE HEATER={bed_heater} TARGET=120
 
-            # Wait until bed reaches temperature
-            TEMPERATURE_WAIT SENSOR="{bed_heater}" MINIMUM=120
+            #Call the non blockin temp loop
+            UPDATE_DELAYED_GCODE ID=check_bed_temp DURATION=1
+#            # Wait until bed reaches temperature
+#            TEMPERATURE_WAIT SENSOR="{bed_heater}" MINIMUM=120
 
         {% else %}
             # Chamber is already close enough to the desired temperature
@@ -604,15 +606,36 @@ gcode:
     # === FINAL BLOCKING WAIT ===
     {% set message = "[CHAMBER HEAT] Waiting for chamber to reach " ~ wait_temp|string ~ "°C..." %}
     RESPOND MSG="{message}"
+    # Call Delayed Gcode to monitor chamber temps.
+    UPDATE_DELAYED_GCODE ID=check_chamber_temp DURATION=2
+    
+#    # Block until the chamber temp sensor reads the required temp
+#    TEMPERATURE_WAIT SENSOR="{sensor}" MINIMUM={wait_temp}
+#
+#    # Confirm chamber is ready
+#    {% set message = "[CHAMBER HEAT] Chamber ready at " ~ printer[sensor].temperature|round(1)|string ~ "°C" %}
+#    RESPOND MSG="{message}"
 
-    # Block until the chamber temp sensor reads the required temp
-    TEMPERATURE_WAIT SENSOR="{sensor}" MINIMUM={wait_temp}
-
+[delayed_gcode check_chamber_temp]
+gcode:
     # Confirm chamber is ready
-    {% set message = "[CHAMBER HEAT] Chamber ready at " ~ printer[sensor].temperature|round(1)|string ~ "°C" %}
-    RESPOND MSG="{message}"
-
+    {% if printer[sensor].temperature >= wait_temp - 1 %}
+        {% set message = "[CHAMBER HEAT] Chamber ready at " ~ printer[sensor].temperature|round(1)|string ~ "°C" %}
+        RESPOND MSG="{message}"
+    # Call until the chamber temp sensor reads the required temp
+    {% else %}
+        UPDATE_DELAYED_GCODE ID=check_chamber_temp DURATION=2
+    {% endif %}
 
+[delayed_gcode check_bed_temp]
+gcode:
+    {% if printer[bed_heater].temperature >= 119 %}
+        {% set message = "[BED HEAT] Bed reached 120°C, continuing..." %}
+        RESPOND MSG="{message}"
+    {% else %}
+        # Reschedule delayed G-code until the temperature is met
+        UPDATE_DELAYED_GCODE ID=check_bed_temp DURATION=1
+    {% endif %}
     
 [gcode_macro M106]
 rename_existing: G106