btt_eddy.cfg modified - 17/04/25 - 09:20:12

printer_data/config/btt_eddy.cfg

@@ -1,31 +0,0 @@
-
-[mcu eddy]
-serial: /dev/serial/by-id/usb-Klipper_rp2040_504450612086291C-if00 # This is the serial address of your eddy probe. This can be found by using the terminal of your klipper instance (typically through SSH) and using the command ```ls /dev/serial/by-id``` 
-restart_method: command
-
-[probe_eddy_ng btt_eddy]
-sensor_type: btt_eddy
-i2c_mcu: eddy
-i2c_bus: i2c0f
-x_offset: 0 # INSERT VALUE FOR YOUR PROBE POSITION
-y_offset: 36 # INSERT VALUE FOR YOUR PROBE POSITION 
-reg_drive_current: 15
-tap_target_z: -0.6
-tap_start_z: 3
-tap_mode: butter
-tap_threshold: 135
-tap_samples: 5
-tap_max_samples: 10
-tap_samples_stddev: 0.025
-tap_speed: 2
-tap_adjust_z: -0.225
-
-[temperature_sensor btt_eddy_mcu]
-sensor_type: temperature_mcu
-sensor_mcu: eddy
-min_temp: 10
-max_temp: 100
-
-[temperature_sensor btt_eddy]
-sensor_type: Generic 3950
-sensor_pin: eddy:gpio26